The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
front subframe question
- Thread starterkaiju
- Start date
lunchbox
Well-known member
No.
DR1665
Well-known member
This is the only difference I ran into that was bothersome when I used a FWD core support on 195/2000. EDIT: In this picture, the core support is facing the ground. Everything is rotated 90* to the left so it would sit on its own for comparison. EDIT2: GVR4 bit is in the background here.
My plan is to clean up the old "boxes" and weld them to the FWD sub-assembly. That will probably happen when I decide to pull the engine and re-do my front end repairs. (They're fine, but I want to be able to drag the car out of a ditch without ripping the entire front end off if I stuff it.)
My plan is to clean up the old "boxes" and weld them to the FWD sub-assembly. That will probably happen when I decide to pull the engine and re-do my front end repairs. (They're fine, but I want to be able to drag the car out of a ditch without ripping the entire front end off if I stuff it.)
Last edited:
