SleepinGVR4
Well-known member
Are 90-94 AWD TEL subframe bushings the same on our cars?
The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
90-94 AWD TEL subframe bushings...
- Thread starterSleepinGVR4
- Start date
moduleunknown
Well-known member
Yes, and if you want to replace the bushings in the front crossmember, the two smaller subframe bushings can be used (but then you need another set).
SleepinGVR4
Well-known member
That's exactly what I want to do. But why would I need another set? I only plan on replacing the front crossmember bushings.
The subframe bushing set is designed for the crossmember that houses the steering rack. If you're only going to do the front crossmember than you are left with two extra bushings, or buy two sets and you can do both crossmembers/subframes.
EDIT, all of this is assuming that you are going to use Poly bushings. If you're going OEM none of this "bushing set" talk applies.
EDIT, all of this is assuming that you are going to use Poly bushings. If you're going OEM none of this "bushing set" talk applies.
Last edited by a moderator:
SleepinGVR4
Well-known member
I can't do the subframe right now. So I'll have some extra bushings for later.
My buddy did his car with just one set. Two in the front and two in the rear. We figured that with everything bolted together, the end result should be basically the same as if we replaced all 6 bushings.
