LordAthey
Well-known member
I'm going to be replacing the rod bearings, and all the bearings on the bottom end (main and so on). Which bearings would you use and where would you get them from. I have stock 1g rods with je pistons.
The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
bearings
- Thread starterLordAthey
- Start date
524of1000
Well-known member
I use ACL as do anyone else I've worked on these cars with. Clevite (?) seem to be popular as well.
ApexHunter
Well-known member
OEM are good too.
Jesh
Well-known member
I rebuilt my engine about 900 miles ago, and i used ACL half groove main bearings, and plain old ACL rod bearings. they looked identical to the ones that were in there. And to my knowledge the engine had never been rebuilt.
Last edited:
Terry Posten
Well-known member
ACL race.
ACL FTW! My 2 cents.
mitsuturbo
Well-known member
ACL and Clevite are good.
Hi-Tech are rebranded ACL.
Hi-Tech are rebranded ACL.
