You should have posted this in newbs, just saying.Dif noise left turn only is unlikley, jackshaft brg left turn only is also unlikley. these brgs turn all the time & would not change in load on a left turn. more likly a wheel brg or a backing plate to near the rotor.

Quoting galantrevolution: Does anybody have a picture of their car with the springs with out cutting them ?I no longer have any before pics but this is with 1.5 coils cut out of rear.

H&R are the only direct fit option I am aware of. they will leave it sitting fairly high in the rear. most of us who have installed them have cut some of the dead coils to give the rear the appropriate drop.

What solved the problem? That others may know in the future.

You need to properly check your charging system. sounds like you're just running off the batt till it's out of juice. I'd start there.

That I can live with. Just no balls dangling in the back. I wanna castrate every car/truck I see with those.

I'm in for a set.

I'll check I may still have my old rack. if so you're welcome to it.

Sorry to say the finding of more damage awaits you. while running a missing ground will slowly overheat things but during cranking it'll take any route it can & overheat melt any circuit that cant take the load.

^^Use 3m window weld not silicone. it's liquid urethane & works very well. I have the Avids myself but my epic build is far from done so I can't say on rattles.

OK it sounds like the dust seals have fluid building up behind them. the seal that's leaking is the square cut seal inside that you can't see. replacing the ones you see will not fix the problem. you need to pop out the piston & replace both or in other word, rebuild the caliper.

If you look at the "disabling alarm" tech thread I had put a couple o pics in there with where the etacs is mounted in the car but... if your windows are powering up your problem does not lay there. it only provides power to the windows it does not control individual window function.It sounds...

P.m. me if sale falls through.

Hit me up on pm I have a good extra four bolt w/axles & cups, one inner boot is torn. happened while removing it under less than Ideal circumstances. I'm down in sd a lot, could drop it off to you.

Do they have a us distributor? Side note I may have an unused harness bar available soon