The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Buying ECU

When getting my ECU does it matter if it was out of a FWD or AWD. Just as long as it's a 5 SPD and Turbo ECU right?
 

Terry Posten

Well-known member
Joined
Dec 16, 2003
Messages
9,009
Location
Davenport, Iowa USA
All you need is an ECU from a TURBO 1G/GVR4 that is an EPROM board. I would stay away from a 90 TEL turbo ECU because you would have to swap 2 wires around on your harness to make it work correctly.

Auto, FWD, AWD does not matter. The chip that you have made will allow the car to run great as long as you tell the programmer (Keydiver) what you have in your car.
 

Ok thanx, Got a 94 5 Speed Eprom rebuilt( New Caps) and socketed. number MD304482-E2T60871-
EB21..
 

Good decision. The 1994's have better caps, so they never leak. But, you MUST change chips before you can use that ECU, as it has emissions stuff in it that can't be turned off.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top