toybreaker
iconoclast
- Joined
- Apr 30, 2006
- Messages
- 3,581
put this here for input, mods feel free to move or delete /ubbthreads/images/graemlins/wink.gif
Notice the little buggers always break just below the surface, and usually at an angle.
Center puching the exact center will give us a place to start.
Did I say the exact center? .... /ubbthreads/images/graemlins/rofl.gif ...
It may take a few shots to make a starting point, but now is the time to pay attention. You will be basing every step after this on the center point, so time spent here will pay great dividends later.
Drill a small, short hole with a 1/16th's inch bit.
It doesn't need to be deep, just on center.
Notice the little buggers always break just below the surface, and usually at an angle.
Center puching the exact center will give us a place to start.
Did I say the exact center? .... /ubbthreads/images/graemlins/rofl.gif ...
It may take a few shots to make a starting point, but now is the time to pay attention. You will be basing every step after this on the center point, so time spent here will pay great dividends later.
Drill a small, short hole with a 1/16th's inch bit.
It doesn't need to be deep, just on center.
Last edited: