desant78
Well-known member
Hello gvr4.org
I have upgraded to a E3 16g, and when I went to install my 2.5" DP, the flange did not fit. This forced my hand to use the full 3" exhaust I have. Unfortunately, while it bolts up it's stupid loud. With a e3 16g pushed, from 18 to 22psi, am I going to see a major advantage using the 3" over 2.5"?
I'd prefer the 2.5" because it' smuch quiter, and the 3" is VERY low to the ground, while the 2.5" is tucked very nicely.
As always, opinions appreciated.
thanks again!
I have upgraded to a E3 16g, and when I went to install my 2.5" DP, the flange did not fit. This forced my hand to use the full 3" exhaust I have. Unfortunately, while it bolts up it's stupid loud. With a e3 16g pushed, from 18 to 22psi, am I going to see a major advantage using the 3" over 2.5"?
I'd prefer the 2.5" because it' smuch quiter, and the 3" is VERY low to the ground, while the 2.5" is tucked very nicely.
As always, opinions appreciated.
thanks again!
Last edited: