I have seen past suggestions on using 2 -6AN adapters (Earl's PN991954) and 2 -6AN Caps to block off the rear steering rack before. I like the idea because you don't have to cut up and weld the rack shut, like if I don't sell my car it could easily be replaced. But what never gets mentioned is which exact lines do you use the adapters/caps to block off? The fittings on the oem long RWS pressure lines look similar to the adapters that you need but I am not quite sure. If somebody would circle the actual lines and where to cap them, that would make it a lot easier
-Front Rack
-Rear Rack
-Front Rack
-Rear Rack