PJGross
Well-known member
Anyone have a trick tool to access the lower TPS bolt/machine screw without removing the fuel rail?
I'm pretty sure 12 years ago I rigged something up to loosen this one even though I obviously didn't adjust it properly since I'm seeing .60V at idle instead of .63V
I was thinking of cutting off a phillips bit and grabbing it with a needle nose vice grips?
I tried a set of craftsman right angle "distributor" wrenches, but the 8mm is too awkward to get a bite.
Of course I can remove the fuel rail but that's sort of a pain. I'm sure there is a trick to it.
Thanks,
PJ
I'm pretty sure 12 years ago I rigged something up to loosen this one even though I obviously didn't adjust it properly since I'm seeing .60V at idle instead of .63V
I was thinking of cutting off a phillips bit and grabbing it with a needle nose vice grips?
I tried a set of craftsman right angle "distributor" wrenches, but the 8mm is too awkward to get a bite.
Of course I can remove the fuel rail but that's sort of a pain. I'm sure there is a trick to it.
Thanks,
PJ