twonineseven
Well-known member
To the guys on here that installed a custom FMIC set up, What/how did you re-route the power steering cooler?
The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
FMIC install questions
- Thread startertwonineseven
- Start date
HHIVR4
Well-known member
I just bent mine out of the way.Dont kink it though.
twonineseven
Well-known member
Ok, i also heard to loop it, has anyone else done this i am hesitant to do this bc i'm not sure if it will damage power steering. any feed back is much appreciated on any install problems you guys have ran into.
atc250r
Staff member
I removed mine altogether. No need to loop them, when you unhook the rubber hose from one end of the hard line and twist it around, it will go right onto the PS reservoir.
John
John
turbowop
Well-known member
Looped/unhooked on both my cars. No issues.
fivestardsm
Well-known member
I used one out of a 91 SOHC galant. I had to bend it just slightly to get it to fit. But my setup is a very close tight fit.
Pry it back & use a tie strap to keep it off the fmic.
