tektic
Well-known member
I'm putting together a nt eclipse I just bought and would like to throw in a lightweight flywheel I have for an awd. I've seen people say it is the same size ring gear and it will work. Then I've seen other people say it doesn't fit in the bell housing because it's too tall. Has anyone done this successfully?
I just measured the two bell housings and couldn't find any where the nt was narrower than an awd trans. The ring gears are the same distance from the block and the distance between the teeth and end of the pressure plate is the same. I don't see why it won't work.
I just measured the two bell housings and couldn't find any where the nt was narrower than an awd trans. The ring gears are the same distance from the block and the distance between the teeth and end of the pressure plate is the same. I don't see why it won't work.