Anybody with CAPS or knowledge, have any idea if a Galant FWD 91-92 gas tank will fit on a VR4?

1G DSM link for sale. Bought this last fall for my Galant and never installed it. I have a Keydiver chip, and my Galant runs great, and I'm gonna leave it as is for now... I just bought a Jeep Liberty CRD, and I've been busy throwing money and time into the Jeep! The DSM link has been sitting on...

AFTER I ordered new moog inner tie rods and boots for 140.00, I discovered that I can get an entire rack, with these parts already installed on rock auto for 198.00! The rack I am looking at is a reman for a 91 Eclipse GSX. This will fit correct? (I've already removed and plugged my AWS ports...

I've read forums til my eyes hurt! All I want to do is bore and freshen up my short block. I've read about evo9 pistons, 2G pistons on 1G rods, and machining the 1G rods to fit, and so on. I'm not opposed to spending 4-500 on new pistons that will fit the 1G rods, 8.3:1 wiseco or similar. I am...

So, I go to change timing belt, tensioners, water pump etc. The Galant has been spewing out blue smoke at startup, and I figured the valve seals are bad. 194k mi on all original engine. I decided to try replacing the seals with the head still on using either the rope trick, or compressed air. I...

Hey Guys, I picked up some cams and other DSM stuff from a guy. He claimed the cams were from a Buschur Head (2G DSM). I'm thinking about putting them in my galant. The intake cam has numbers engraved on it that read:101-201-8I, then below that it says UI2802, there is also two c's engraved...

I picked up a 97 Eclipse GSX for 500. The engine is in pieces (head removed) timing belt broke. I took off the timing covers, and find there's no crank sensor. The car has a 2G intake and head, but had a "black cap" cam sensor installed, and the wiring for the black cap sensor has been extended...

Looking for a long block that is within a reasonable driving distance (200mi or so). I picked up a 97 Eclipse GSX, timing belt broke, somebody removed the head, and left it sitting for years, block exposed to weather, cylinders all rusted up, etc. I figured dropping in a complete 6 bolt would be...

Thought this info could be useful to others...The ECU coolant temp sensor part number MD069879 crosses to a Borg-Warner WT3005 which can be found at most local auto parts stores for less than 20 bucks... It looks like this...-Mike-

One for the ECU gurus... I want to eliminate the pull up resistor on my ECUs egr temp input. I've been following traces and flow thrus on my ecu till my eyes hurt! Anybody here know where the pull up resistor is located? Hope it's not built into one of the vertical ceramic ICs!... Thanks! -Mike-