I have the trans out of my car due to catastrophic failure and I noticed that my splines on my input shaft are about ready to strip out. My clutch hubs are also ready to strip out. I am running a Quarter Master twin disc with the hardened hubs in the discs. I have already stripped one set of discs out. Does anyone make a coupler that will slide over my input shaft making full contact with the splines from start to finish and adapts it to a bigger more aggresive spline for a chevy or something with a large input shaft or am I going to have to make one, cause this is getting old.
Thanks for the input guys, Chris
P.S. Does anyone know the Rockwell of the input shafts?
Thanks for the input guys, Chris
P.S. Does anyone know the Rockwell of the input shafts?