GreenGSX
Well-known member
I can get a sheet of 4x8' white 1/4" aluma-lite for $88 locally. If we are going to add rear down force with a wing maybe we should talk about a quick front splitter? Shouldn't be too complicated. Here are some rules of thumb.
1. It cannot mount to the front fascia. You should be able to remove the bumper cover and leave the splitter on
2. it should be at least 3" from the lip of the fascia and not follow the lines of the bumper. think semi-circle
3. it should be removable for transit driving. think clevis pin mounts
4. low cost quick build hardware store turnbuckles
5. it can be lower then the bottom of the factory bumper. think small filler panel to close up the gap
1. It cannot mount to the front fascia. You should be able to remove the bumper cover and leave the splitter on
2. it should be at least 3" from the lip of the fascia and not follow the lines of the bumper. think semi-circle
3. it should be removable for transit driving. think clevis pin mounts
4. low cost quick build hardware store turnbuckles
5. it can be lower then the bottom of the factory bumper. think small filler panel to close up the gap