citymunky
Well-known member
Looking for one, let me know what you got.
The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
WTB: HKS thottle body elbow
- Thread startercitymunky
- Start date
CheapTalon
Well-known member
I haven't seen one of these in ages. What do they typically sell for? And are they dimensionally the same as a 2g?
citymunky
Well-known member
I just sold one a few months back, I think they are a bit bigger than a 2g, but I could be wrong.
fuel
Well-known member
I too am chasing one! I think the inlet pipe diameter is the same as a 2G elbow but the interior sizing is better especially as it doesn't taper down to the 2G's 55mm and matches the VR-4's 60mm throttle body. I ended up using a die grinder to improve the 2G elbow but I feel it is a bit thin in places and an HKS one would be far better (and period correct!)
