MRmeeTooxD
Well-known member
Replacing gasket an snapp!!! A bolt breaks, gonna need hotside for evo 3 16g!!!!:, (
The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
WTB: 16g hotside
- Thread starterMRmeeTooxD
- Start date
idreamidrive
Well-known member
Drop hotside off at machine shop and have them get it out and install a helicoil.
MRmeeTooxD
Well-known member
Yea looks like I'm going to have to do that....
OneMoreVR4
Well-known member
a machine shop will have a hell of a time with that. ur best bet is disintegration. check out Witt disintegrating in addison il. ive used them several times for this exact same thing. it was $50 one day turnaround. u dont want a helicoil in ur turbo
strokin4dr
Well-known member
I have a 16g hot side. It is not from an evo 3 16g though.
prove_it
Well-known member
Have a welder weld a nut or bolt to the broken off chunk. 4/5 times the heat induced from the weld will loosen up the broken bit and the new nut/bolt will have a surface to get a socket on to remove it.....
If you don't get it repaired, I'll pay shipping to have it sent my way.
If you don't get it repaired, I'll pay shipping to have it sent my way.
Last edited:
