Bimmubishi
Well-known member
Hi Everyone. I need some help with this transfer case issue I'm having. Hopefully there is a solution.
I've installed a Ralliart dogbox in my Evo. It has the following gearing.
Front ring and pinion- 4.26
1st- 2.06
2nd- 1.50
3rd-1.19
4th-.958
5th-.807
From what I understand and study this should work with my 3.909 rear end when combined with the 1.09 Evo 2 transfer case (which also comes on a US model, forget which year 2g.. )
If the above assumption is correct then I will need:
A 1.09 Transfer case with a 22 spline input shaft. Does this even exist?
The dogbox has a 22 spline output shaft. I could possibly swap my shaft in but NOOOO the Ralliart box has a slightly larger VC unit which resides on the other end of that shaft so the Evo II shaft will not fit the Ralliart VC.
So complicated!
Does anyone know if there has been a Mitsu with a 22 spline 1.09 transfer case? /ubbthreads/images/graemlins/idea.gif
(Am I way offbase here?)
Thanks!
Alex
I've installed a Ralliart dogbox in my Evo. It has the following gearing.
Front ring and pinion- 4.26
1st- 2.06
2nd- 1.50
3rd-1.19
4th-.958
5th-.807
From what I understand and study this should work with my 3.909 rear end when combined with the 1.09 Evo 2 transfer case (which also comes on a US model, forget which year 2g.. )
If the above assumption is correct then I will need:
A 1.09 Transfer case with a 22 spline input shaft. Does this even exist?
The dogbox has a 22 spline output shaft. I could possibly swap my shaft in but NOOOO the Ralliart box has a slightly larger VC unit which resides on the other end of that shaft so the Evo II shaft will not fit the Ralliart VC.
So complicated!
Does anyone know if there has been a Mitsu with a 22 spline 1.09 transfer case? /ubbthreads/images/graemlins/idea.gif
(Am I way offbase here?)
Thanks!
Alex