Spyder
Well-known member
Like the title says, I my car maintains 2500 RPM at cold start until it warms up.
Any suggestions? Vacuum lines on intake are plugged.
Any suggestions? Vacuum lines on intake are plugged.
The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
High idle at cold start: 2500 rpm
- Thread starterSpyder
- Start date
transparentdsm
Well-known member
did it just start happening or did you just get the car together?
ISC, FIAV or BISS would be my guest.
edit: or throttle body shaft seals.
ISC, FIAV or BISS would be my guest.
edit: or throttle body shaft seals.
Last edited:
Spyder
Well-known member
New engine rebuild.
New Biss screw. Cyclone intake. Stock throttle body.
New Biss screw. Cyclone intake. Stock throttle body.
Spyder
Well-known member
what is ISC and FIAV?
transparentdsm
Well-known member
the block that is on the bottom of the throttle body. the part that allows coolant to run through it.
if its a new engine build, you need to warm it up and set the idle.
if its a new engine build, you need to warm it up and set the idle.
Spyder
Well-known member
Set the idle with the biss screw? I did that part. Not sure what else I can adjust.
I did replace the Throttle Position Sensor as well.
I did replace the Throttle Position Sensor as well.
transparentdsm
Well-known member
well what about the ISC and FIAV, do you have a block off plate or are you using them.
