Evening.As I am going to take the VR4 to the rally of the bay and not just Khanacross the car, I have decided to drag out my version of rocking horse poop.A "New" pair of Green VR4 hubs! (Yes, very pretty, no, im not saying how much I paid... they were not cheap!) Yes, Unused and in...

Cool, Sounds like its Fidanza time!That leaves me some christmas coin!

To make it shiney you have to make it dirty first...Pity you cant keep paint on the front bumper!

To show my lack of knowledge...Why do people Fit Hyundai Valve covers?

Morning allSo now as Ive now got a VR4 that apparently goes really well... If you are over 4500rpm I think the camtiming is wrong! ( Evo8 MR cams )Or needs a good tweakin!So I can either pay an exorbitand $800 for HKS ones, ( Fleabay its $600 from the US) Gte Geoff OToole to make some...

Well, Ive got a rallycarWith EVO8 MR cams (almost identical to the Kelford rally Grinds..) small 16g with 34 mm restrictor and a SMC Autronic.. And an ex works Dumppipe! I dont run antilag.Does anyone have an idea which manifold works the best ?, the car has a Cyclone but I have a EVO 0...

Awesome! So from what i can see, one Valve controlls the Butterflys and the other controlls the Vacuum on the fuel reg ( to give it a nice idle...)Right or wrong???

Good afternoon.Im after the vacuum / Emmision line diagramme for a JDM VR4 ( ive only got the US manual not the Japanese manual ) As ive got a cyclone manifold.Any ideas Where i can get that from?

Its possible..... Its doable.... you have to get the CAS slot right :/ ( I had it 30 degrees out so I made it work by cutting the slot out of teh CAS, Im goung to weld some bits on to increase the slot length..)It GOES HARD!For keen punters, the Timing looks pretty close to the Kelford...

Its possibleJust get the CAS slot in the right place :/

Ive been able to locate some EVO 8 lifters that are in good nick.Mine are rattily...So the question is...Can a set of EVO 8 lifters fit in a VR4?

after some carful skulduggery ive got the Intalke cam slotted for the CAS....Shal attempt on Wed...

Thread from the dead... Morso I can find this thread again!Ive got the Cams from a MR ( Bigger lift and duration than a std EVO) Whats critical is the people who have done it CORRECTLY have left one small bit of info out...Its all about 165 deg out from standard! Which means it works (...

Ok, there was ANOTHER thread on this ( 5 pages worth..) and I cant find it now!anyone know which one it was?

Well, Ive got a bit further...You have to cut the CAS slot onto the Intake Cam as the exhaust does teh Timing on an EVO8 and the cams are approximately 180deg out..unless the cams are asymetrical and the intake can do the exhaust!