I recently decided to let go of 820. It was an awesome car, but I just didn't have time to keep up with it anymore. Luckily, it went to a local enthusiast who already owns another Galant...So basically from one Galant hoarder to another, which is probably best case scenario.Here are the pics...

The only support provided is by the small bracket and grommets (pictured in the photo you mentioned). If they got tweaked a bit you should be fine bending them back. The weak point is at the core itself where the tubes attach. You likely won't know if they are fucked up until you run the car and...

Yeah, I swapped in one of the aluminum OSC models (OSC 98780) from RockAuto into 820 a few years back. Worked great. IIRC, I had to get new foam from the hardware store, but otherwise it was pretty much plug and play.Removing the dash sucked f***ing ass though. Have fun with that. Make sure...

Mine is just screwed in.Where'd you get it at? Haven't seen one of these for sale in years.

Lol. Yep, sounds exactly like Steve's work. If I were you, I'd go through anything he touched with a fine tooth comb.Regarding the water line, try using a pair of vise grips after you heat the fitting. Sounds like the line is already trashed, so vise grips won't hurt it. Get them nice and...

Your best bet would be to join any Facebook groups you can find (both DSM and Galant related) and put feelers out there.You could also PM citymunky and see if he has any idea where it is now: https://www.galantvr4.org/threads/fs-1991-galant-vr-4-923-2000-chesapeake-va-sold.13524/

This.@Vr4Ape35 Sorry dude, there's no salvaging that thing. At best you could strip it down to a shell and swap parts to something cleaner.

For a few hundred more you can get a lower end coil over that's pretty decent:https://fealsuspensionstore.com/feal-coilovers/?_bc_fsnf=1&Make=Mitsubishihttps://shop.bcracing-na.com/collections/coilovers/products/89-92-mitsubishi-galant-vr4?variant=19572147552344...

Headlight covers? Wat dem?

I like this guy already.How's it look with the bumper installed?

Went from selling out to full on CAN bus.Not gonna lie, the gauges look dope. But can you do this?

Out with ECMlink eh? When/why did you decided to swap over?

PM sent

I don't think so, but then again, I can't say for sure. Most of the fuel system components are pushing 30 years old at this point, so hard to pinpoint where the sh*t in the system came from. I do know, now, what it takes to keep it from getting into the injectors though.Do it soon, and...

Out of the garage, which is rare these days: