Turbo99
Well-known member
No, this isn't a thread about where can I get it or what's the part number, so put the pitch forks down! /ubbthreads/images/graemlins/grin.gif
The VR4 I picked up had the windshield replaced, and when the trim was put back the top corner pieces don't sit flush, they stick up a bit (you could put a piece of paper under them from the outside onto the windshield glass or run water underneath them.
Any idea why they're not sitting flat? If you give them a lil push they just pop right back up. Are they supposed to snap into place, or am I missing something here?
Thanks!
The VR4 I picked up had the windshield replaced, and when the trim was put back the top corner pieces don't sit flush, they stick up a bit (you could put a piece of paper under them from the outside onto the windshield glass or run water underneath them.
Any idea why they're not sitting flat? If you give them a lil push they just pop right back up. Are they supposed to snap into place, or am I missing something here?
Thanks!