91Vr4white
Active member
Old clutch was worn out slipping ect. replaced clutch with an oem replacement. Had the flywheel machined with steps by a place that machines flywheels on big trucks. ( stepped clutches are common on big trucks). After install had no clutch pedal. Didn't undo any lines ect. Bleed the system new fluid feels little better and can shift but just barely. Have about an inch of actual clutch pedal and its hard as a rock. Any one have an idea what the issue could be? I've bleed the system over an over at the slave. You can watch the fork move inside the bell housing and it looks like its moving all the way. So I don't think it's the slave.
Thanks for any input.
Thanks for any input.