The_Big_Weave
Well-known member
I melted a piston a while back and now I need to rebuild. I have a set of eagle rods and I am looking to go with wiseco stock bore pistons.
Would have any problems with this if I just honed the cyl. and put pistons in?
Would it just be easier to go stock with this route?
Do I have to balance the crank with everything? dont really have a shop so I was hoping to just put the pistons in with out having to pull the crank.
And I also have a balance shaft removal kit, can I put this in with out taking out the oil pump out?
Would have any problems with this if I just honed the cyl. and put pistons in?
Would it just be easier to go stock with this route?
Do I have to balance the crank with everything? dont really have a shop so I was hoping to just put the pistons in with out having to pull the crank.
And I also have a balance shaft removal kit, can I put this in with out taking out the oil pump out?