I just picked up some 1g rods machined for 2g pistons from ebay, they are used and one piston was bad
the seller remove the piston, so no clue what happened. My question is should the wrist pin hole be perfectly center?
in the pic it is not, and I cant be sure if the other 3 since the pistons are still attached.
the 3 pistons look "ok" I havnt miced them or anything yet, wanted to be sure of the rod situation first.
Should I send them out to be checked out, or will they just tell me they are bad?
the seller remove the piston, so no clue what happened. My question is should the wrist pin hole be perfectly center?
in the pic it is not, and I cant be sure if the other 3 since the pistons are still attached.
the 3 pistons look "ok" I havnt miced them or anything yet, wanted to be sure of the rod situation first.
Should I send them out to be checked out, or will they just tell me they are bad?