Quoting construct1:
so where would i drill to have it properly lined up
currently i drilled it out larger to fit the prothane bushings sleeve for a 5/8 bolt thats going in their
so when i took the pic trans was jacked up to line up the hole and saw its a couple inches off
so when i take it off the jack it will go down onto crossmember obviously because thiers no bolt in their
but i cant just drill holes all over it, naturaly it should be a couple inches off the crossmember but
where is the right height, any one have a measurement of theirs from the crossmember to the bolt hole height when the car is on the ground
Download the factory service manual and it will show you the proper height in the mounts before you tighten them down.
If you are using solid inserts, then all you can do is line it up so the bolt slides in. IF things are misaligned at that point, there are great issues, but assuming
all the proper parts being installed at all 4 corners and no shoddy install work, it should all line up without too much grief.