My doors are rusting at the bottom below the molding and only on the inside. Previous owner said that a wire brush would clean it up, but it is a bit more than that.
How can I take care of these areas and stop the rust? I could always use POR 15 after brushing/sanding/wire brushing etc., but I am worried that I won't be able to get all of the rust out and will be wasting my time. There is a seam at the bottom of the doors and figure that rust could be getting in there as well.
Is there anything that I can do about this?
Thanks
How can I take care of these areas and stop the rust? I could always use POR 15 after brushing/sanding/wire brushing etc., but I am worried that I won't be able to get all of the rust out and will be wasting my time. There is a seam at the bottom of the doors and figure that rust could be getting in there as well.
Is there anything that I can do about this?
Thanks