chucklesas
Well-known member
Okay, so I think the knock sensor is pulling my timing, even at idle I show 9 counts of knock and I assume this is a safety feature when the knock signal is bad? Anyway, I pulled my harness apart, it appears someone else spliced this wire before I did (didn't peel it that far back the first time), because of this, when I put my wiring together I had reversed the ground and the signal wires (hence my code 31). I'm trying to solder in a new coax (I'm just going to use the techniques our electrical guys do on the airplanes to splice in a coax). Getting to my real question... Is the shielding supposed to be connected to the black ground wire that runs up to the knock sensor? I peeled the harness pretty far back and saw that the coax wire had been spliced to the black ground wire. If someone could call me with the answer, I'd appreciate it: two one six four zero one eight seven nine one
Thanks.
Thanks.