so I'm looking closer at your seat rails. looks like you have them mounted low as possible. I like that. how is the vision out over the hood? lol I drove an integra one time with s2000 seats, was difficult to drive because it sat so low. from the looks of it your sit lower than the famous Curtis brackets.
1991 GVR4 #613 1966 Chevrolet Chevy II Nova 400 4dr Sedan V8
Posts: 540 | From: Lake Stevens, WA | Member Since: 11/18/11 | IP: (220.127.116.11) |
I am 5'9" and can see perfectly fine. the seat is still angled so the shorter you are the higher the seat will get when you adjust it forward. but i still have at least 1-1.5" extra room for a helmet compared to other brackets.
Quoting prove_it: How much to machine my center diff housing Evan?
hahaha honestly it would be less of a headache for me and cheaper for you to just have Jacks transmissions to do it. lol. I only did it because I wanted to see how it was done. $10.00 bearings and shims and my time was worth the learning experience.
Quoting GSTwithPSI: Looks great, Evan. That catch can is legit.
Which size BEP housing are you running?
It's just the basic housing for the HX35. Nothing special but in the long run I will ether upgrade the turbo to something a lot nicer or I will use the 12cm twin scroll housing and make a proper manifold.