GalantVR4.org The Mitsubishi Galant VR-4 Forum
NOTICE: This forum is for archiving information and discussions. Please do not reply to threads unless you have valuable information to add. Do not post questions or problems here.

Forum | Search | New user | Login | Who's Online | FAQ
Galant VR-4 Forums » Galant VR-4 » How To and Info Archive » Re: CAPS Requests
Previous thread Next thread

Re: CAPS Requests

PastaRocket
Unregistered


 Galant VR-4 org Post #: 375199 posted 08/28/06 06:21 AM     Remind Me!  Send Private Message   Edit Post      
Anyone know the part# for rear sway bar links??
| | | IP: (65.82.138.66) | Report this post to a Moderator

mysticj
Newbie


 Galant VR-4 org Post #: 402093 posted 11/03/06 02:03 PM     Remind Me!  Send Private Message   Edit Post      
VIN: 4A3AJ56L2RE111727
Camshafts
Posts: 10 | From: garnett, sc | Member Since: 07/29/06 | IP: (24.172.67.10) | Report this post to a Moderator

Petey G
Unregistered


 Galant VR-4 org Post #: 402096 posted 11/03/06 02:09 PM     Remind Me!  Send Private Message   Edit Post      
inlet md193628 which superseeds to md335760
exhaust md190853
| | | IP: (63.149.92.66) | Report this post to a Moderator

b00st33d
Member


 Galant VR-4 org Post #: 471601 posted 04/30/07 12:04 PM     Remind Me!  Send Private Message   Edit Post      
I need part # for the half shaft seal to the transmission.
Thank you.
Posts: 239 | From: Central, CA | Member Since: 02/06/06 | IP: (66.42.85.244) | Report this post to a Moderator

Scott Y
mighty skunk hunter
953/1000


 Galant VR-4 org Post #: 484025 posted 05/24/07 08:52 PM     Remind Me!  Send Private Message   Edit Post      
Need to know if the lower passenger rear control arm is the same between a 1G and GVR-4. Mine has a corkscrew twist in it and needs to be replaced.


Scott Y
Posts: 482 | From: Lakewood, Colorado, USA | Member Since: 05/08/01 | IP: (24.244.97.164) | Report this post to a Moderator

Hertz Galant VR4.org Administrator
OneTitle to rule them all.
77/2000


 Galant VR-4 org Post #: 581729 posted 12/26/07 05:49 PM     Remind Me!  Send Private Message   Edit Post      
CAPS online e39a


Ryan Hertz


Edited by Hertz (12/26/07 10:47 PM)
Posts: 13500 | From: Chicago, IL | Member Since: 07/29/02 | IP: (75.3.120.40) | Report this post to a Moderator

GVR41560
Unregistered


 Galant VR-4 org Post #: 582267 posted 12/28/07 12:09 PM     Remind Me!  Send Private Message   Edit Post      
Have CAPS and cannot figure this one out - went to dealer and they gave me wrong part, and they have CAPS too! Go figure. The problem is, it is on two different pages. Someone help!

The struts on our cars have two bolts. The upper one is shorter and skinnier. The lower one is longer and fatter. I need the number for the upper one. We had an alignment done and the shop took the original and replaced it with an eccentric bolt to be able to better align the caster after the wrecked side got pulled out. And they kept it.

I have bought the lower, fatter one which I don't need.
| | | IP: (69.111.131.75) | Report this post to a Moderator

HunterDG
Junior Member
690/1000


 Galant VR-4 org Post #: 585169 posted 01/05/08 08:22 PM     Remind Me!  Send Private Message   Edit Post      
Quote:

CAPS online e39a



guys, maybe i'm missing something, but the above link is to the Asian E39a

the American e39a is here: American E39a

there are both California and Federal emissions versions (CAL vs FED)


690/1000.GVR4.AWD.AWS.Ksshhhh

Edited by HunterDG (01/05/08 08:23 PM)
Posts: 96 | From: Tulsa, OK | Member Since: 07/18/07 | IP: (24.253.240.193) | Report this post to a Moderator

BoostedAWD91
Senior Member
815/2000


 Galant VR-4 org Post #: 589808 posted 01/14/08 09:32 PM     Remind Me!  Send Private Message   Edit Post      
i need the part # for the brake master cylinder bracket


#815/2000- Lexus Pearl White

Posts: 2937 | From: Danville,Pa | Member Since: 03/01/07 | IP: (71.181.180.234) | Report this post to a Moderator

FlyingEagle Galant VR4.org Moderator
Eager Beaver


 Galant VR-4 org Post #: 599546 posted 02/03/08 04:55 PM     Remind Me!  Send Private Message   Edit Post      
Quote:

Quote:

CAPS online e39a



guys, maybe i'm missing something, but the above link is to the Asian E39a

the American e39a is here: American E39a

there are both California and Federal emissions versions (CAL vs FED)



I've never had the links be able to load, I keep getting a message like 404 Not connected to the net. What gives, because I never have a problem unless a picture is blocked, but I would get a banner saying so. Any thoughts, because I would like to see the online CAPS setup.


C53A 1 of the ~1500
Posts: 1631 | From: THE Ottawa | Member Since: 03/05/05 | IP: (99.241.55.180) | Report this post to a Moderator

Scott Y
mighty skunk hunter
953/1000


 Galant VR-4 org Post #: 639279 posted 04/26/08 01:38 AM     Remind Me!  Send Private Message   Edit Post      
I need the temp sensor for the single-wire that goes on the back side of the thermostat. Not the AC one up top, not the ECU or the gauge ones on the front.


Scott Y
Posts: 482 | From: Lakewood, Colorado, USA | Member Since: 05/08/01 | IP: (67.165.208.119) | Report this post to a Moderator

mysticj
Newbie


 Galant VR-4 org Post #: 645484 posted 05/13/08 08:17 AM     Remind Me!  Send Private Message   Edit Post      
VIN: 4A3AJ56L2RE111727
Pistons
Posts: 10 | From: garnett, sc | Member Since: 07/29/06 | IP: (96.24.144.120) | Report this post to a Moderator

kitcho
I'm A Canadian


 Galant VR-4 org Post #: 669984 posted 07/16/08 01:27 PM     Remind Me!  Send Private Message   Edit Post      
for someone with JDM caps, I want to know the PN for the screws that hold in the foglights (for the projector fogs). the factory ones are stainless and i'd like replacements.

thanks


- Adrian
1991 JDM "Evolution" VR-4
Posts: 578 | From: canada | Member Since: 09/11/06 | IP: (24.89.87.11) | Report this post to a Moderator

Happy Birthday Scientist
Secretary of the Interior


 Galant VR-4 org Post #: 752308 posted 01/30/09 12:41 PM     Remind Me!  Send Private Message   Edit Post      
This is for the Inside screw MB645509

Inside Screw: MB645510


1988 VR4....Needs a lot of TLC
Posts: 531 | From: Roseau/Dominica | Member Since: 01/18/07 | IP: (207.42.135.82) | Report this post to a Moderator

wowzer
Master Mechanic-Will Travel


 Galant VR-4 org Post #: 754785 posted 02/05/09 09:05 AM     Remind Me!  Send Private Message   Edit Post   
Looking for a control arm with bushings in it?
Posts: 1719 | From: CS, IL | Member Since: 01/15/07 | IP: (64.109.169.4) | Report this post to a Moderator


Pages: 1 | 2 | 3
Previous thread Next thread

Extra information
0 registered and 27 anonymous users are browsing this forum.

Galant VR4.org Moderator:  curtis, steve, atc250r, jcgalntvr4-244, cheekychimp, jepherz, Rausch, toybreaker, iceman69510, pot, FlyingEagle 

Print Thread

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 39234

Rate this thread


News & Events: News | Events
Galant VR-4: Newbies | General VR4 Discussions | Technical Discussions | How To and Info Archive
Marketplace: Parts For Sale | Cars For Sale | Good Guys | Bad Guys
Community: Members' Showcase

Contact Us | Privacy statement GalantVR-4.org

Generated in 0.047 seconds in which 0.031 seconds were spent on a total of 14 queries. Turbo powered.

Hertz's Galant VR-4 Page