The Authoritative Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

FS: New 1G Manual AWD Drop Engineering Motor Mount

minneSNOWta

Well-known member
Joined
May 14, 2011
Messages
362
Location
Eagan, MN
Hey guys.

I have a brand-new black mild steel motor mount with a 75A durometer. These are discontinued and made for 1G's, but I was able to get 3 of them to work fine. From what I recall, this piece did not work on the Galant crossmember, so I had to get a Torque Solution front motor mount. Not sure if the crossmembers are the same between the two. This is why I have this listed under misc. All four new was $340.

$70 shipped.

 

3rdstrikedsm

Well-known member
Joined
Feb 17, 2008
Messages
3,402
Location
32159, FL
Would you happen to know the o/d of the m as well as the length? I need one for my evo 3 if it will maybe fit?
 

minneSNOWta

Well-known member
Joined
May 14, 2011
Messages
362
Location
Eagan, MN
$60 shipped.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top