The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey. Login to browse without most ads.

Bearing noise/whine?

deez

Well-known member
Joined
May 29, 2004
Messages
1,150
Location
Chico, CA
Okay, I just got back from my mechanics and he doesn't know what this is. When pushing the clutch in and driving down the road, we get a whining which leads me to think throw out bearing. But when the clutch is held in, no noise, only when the clutch pedal is moving. Also, it wont make any noise when sitting still and pushing in the clutch unless the revs are up there, then we can barely hear it. Its most noticeable when the car/drivetrain is moving. Any thoughts? The throwout is new Mitsu, Clutchnet clutch, and Jacks Trans, stock transfer case.
 

Hksvr4

Well-known member
Joined
Sep 22, 2004
Messages
3,023
Location
NYC
I think there's an alignment issue with your drive shaft and x-case. This happened to me during decel. There was a write up on this on here.
 

deez

Well-known member
Joined
May 29, 2004
Messages
1,150
Location
Chico, CA
What would cause that? And why only when the clutch fork is moving?
 

deez

Well-known member
Joined
May 29, 2004
Messages
1,150
Location
Chico, CA
That I dont know, I had a shop install it, who I later came to find out they are kinda hacks.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top