Just sent paypal for the under dash cover and 2 of your door lock tabs.

Cost shipped to 80013?

3377729030828458 expires sept.20 for 5%

Here's a video of what the car is doing. click

Also anyway to add videos? Triedo photo bucket but it won't let me due to video being to big even though it's a short video.

Well only thing we found out was my buddies isc was shot and fried the ecu while trying to diagnose the problem. So I'm still having the same problem. Also put a new isc, iac, and tps.

Well think i just found the problem. ecu started smoking. checked ohms on isc and the were high. So ordered a new isc and got a spare ecu as well. Sucks because the one that fried was an eprom one

Has a newer fuel filter in it. Going to test the tps and isc saturday. Also replaced injectors and maf with known working ones to no avail.

I may be able to get ahold of a maf, when i do ill check that. SO i got my logger, not quite sure how to use it quite yet but my 02-f value is 3.49 at all loads. Is this normal? Also ftrl 139%, ftrm and ftrh are approx at a 100%.

Thanks guys, put her on all four to put on my exhaust and all 4 wheels move fine. Bought a data logger from 1glink.com that will be here tomorrow so Friday I'll be able to dig deeper.

Ok so i have a hesitation and bucking issue at all rpms. Revs freely and normally while sitting. The moment i go to take off and release the clutch it loses power and barely wants to move. once i finally get it rolling it bucks and hesitates. Cant even drive it now. Where should i start digging...

Anyone have the evo 8 piping kit for the gvr4? If you also have the intercooler core that'd be a plus.

Awesome lmk i want it asap.

Would like one for big 16g, 560cc injectors, 2g maf, 91 oct.

What maf does this come with?

How much shipped to 80013

Just had the motor rebuilt but when i go to start it it takes awhile to start. Sometimes needing me to give to a little gas while cranking to get it to start. I replaced the coolant temp sensor with a oem mitsu one and still same issue. Car Does have a walboro with the the rewire as well. Tried...

Whats the specs on those wheels?

Any more pics of the vpc/gcc? Is it all complete?

what does seemed grumpy mean exactly?

Do you have the engine wiring harness by chance?

Still have one of them? Sorry ran into some issues with my daily so i wasnt able to grab at the time i posted.

How much do you want for it?

As title states i am in need of one to get 1514 back on the road again.

How much for the 3 bolt lsd rear end shipped to 80013?

got a blacktop cas and axle. both working fine, shipped pretty quickly too!

and yes clock works i meant no power as in wont start sorry

Quoting rdomeck: Can you turn your engine over with a wrench? Is your battery charged? You could run a wire from your trigger on the starter and touch it to your hot wire on the battery to eliminate any issues with wiring in the car!Battery is charged, havent tried turning it over with s...

Quoting James: How much power is no power? Does your clock work? Does the radio work? If you have nothing at all I would say check your wiring around the battery/to the starter. A loose ground could cause that.All electronics work I can play my radio, all lights come on in and out.

Cant figure this out. It wont start or even turnover, I pulled the starter and got it tested, came back fine. Got a new battery still nothing. Even replaced my fuel pump and CAS with a black top with nothing remedying the problem. Let me give you guys some back round on the car and the situation...

One without torn boots would be nice.

got a front driver side axle by chance?

the axles you have are they for the front or rear?

awesome if you have the cap as well thatd be even better.

this is a long shot but would you happen to still have the power steering reservoir and cap?

I already bought them.

got 1514/2000 bealize green all options.

How much for the keydiver?

how much for 02 and dp shipped to 80013?

still got it?