The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Search results for query: *

  1. FS: PA, 637/1000, 97k miles, Gray, $7000 (SOLD!)

    Iwould keep yours and paint it
  2. FS: PA, 637/1000, 97k miles, Gray, $7000 (SOLD!)

    seems the same peeps always have dumb stuff to say,beautiful car though glws
  3. FEELER: 1505/2000 Shell, Cheaspeake VA. $150.00

    Bout to head your way here shortly man
  4. FS: drop engeering motor mounts

    Do they create a bad vibration?
  5. FS: MI jdm galant vr4 rs $10k

    Bunch of "master debators" on here op...welcome haha
  6. FS: ETS gvr4 FMIC kit, HKS SSQ BOV

    You have a pm sir
  7. FS: '92 VR4 Green - 80/1000 - Alexandria, VA- $3,000

    Give me a shout I older you my number and emailed as well
  8. FS: O2 housing for use with tial wastegate 38mm

    Is that 110 shipped....22405 va if quote is necessary thanks
  9. SOLD

    I love how turbonegro has to comment on every post EVER put on this site bahahah,the vr4 lurker haha
  10. oil feed

    journal bearing turbo feed from the filter ball bearing feed from the head
  11. Nippon pistons

    junk dont buy em,you gat what you pay for,i have a low mileage set or wisecos if you would b interested
  12. Turbo oil feed question

    feed from the filter housing it just makes sense
  13. Need Clutch Advice

    act 2600 kit dont get a 6 puck unless you have previous expierience driving with 1 2600 will do fine
  14. help on motor swapping

    omg 2 bolts holding the strut to the knuckle then tie rod ends carrier bolts other side same exept carrier jus pop it outta the trans go under drop the tcase chain it up undo mounts done
  15. axels

    91-94 axles your good
  16. OEM Gasket sets?

    cometic cometic cometic buy the best they make full kits dude
  17. engine rebuild

    you can put a motor together piece by piece depending on wut your tryin to do dont buy egay parts u get wut u pay for do eagle wiseco combo fairly cheap cometic makes full gasket kits for us get valve seals and a lil machining and rip or jus go buy 1 already finished
  18. WHAT HEAD GASKET???!!!!

    get a cometic dont copper spray it and def get the head cut
  19. WHAT HEAD GASKET???!!!!

    get a cometic and dont copper spray and def get the head cut
  20. how to loosen the timing belt tensioner without the special tool

    take the 12mm long full threade bolt from the topside of the alternator thread it through the mount and tighten until you can get the grenade pin in this way your not depreesing it to fast its free and easy
  21. how to get IC piping?

    diy pvc works also jegs 2.5 exhaust kit will get it done if you have acess to a welder otherwise you pay for wat u get ya know
  22. More noob questions

    no lift shift is full throttle shift you need to set a rev limit of 7500 keep it safe and most important you need a wideband man tune your air/fuel 10.8 or 10.9 as far as pump gas and 11.1 for 110oct dont go lean start at a low boost setting with a controller and enrich fuel as needed wideband...
  23. New gvr4 owner! Problems... :(

    yes replica dash badges r made all the time and very common the fwd will work and if its running rich your maf is the issue unless you have huge injectors make sure your wiring is good via pinouts 4 your car and not a bad idea to put a new maf in try that and act accordingly
  24. ARP head studs, special tool???

    i use a 9/16ths deep 12 point
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top