The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

Register Log in
  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Recent content by mscatchell

  1. FS: Part out 91 GVR4, #597, aftermarket and stock

    Did your vhl have ABS or did you already delete it? I have a 87 JDM and the pump just started leaking. I'm looking for either a used pump or for the NON-ABS prop valve if you have it. Thanks

  2. Spatchana (aka Pot)

    "Pot" totally came through with some much needed parts for my 87 JDM GVR4, he had some rear seatbelt retractors that I needed since mine only had lap belts in the back. He also had some discontinued trim clips, washer nozzles and a inside door handle in great condition. He even gave me a great...

  3. Need DSM mechanic near chicagoland

    Thanks for the feedback guys, I'll get the charging system checked. I'll also check the ground wires for corrosion, I noticed the clock and radio reset after it died while driving and when it went click dead in the driveway.

  4. Need DSM mechanic near chicagoland

    Going with what FUEL stated my car shows a manufacture date of June 1987 and the forms say 1987 Galant

  5. Need DSM mechanic near chicagoland

    There's a whole story behind the issue. But I literally would have to type a story. On a more recent note, Friday night I pulled it out the garage no prob. Went a hr later to start, click nothing (no crank no start) Put the jumper box, starts no prob. Go for drive, only lasted 5-10 mins. Car...

  6. Need DSM mechanic near chicagoland

    I having an eletrical/charging system issue (no dash lights). Had to leave the jump box on the car last night to make it home. Looks like no HIN today It seems like the alternator is putting out volts not sure about amps. Would appreciate any help

  7. Replacement clutch master cylinder for JDM GVR4

    Before I destroy anything, any way to check if this part number will work on a JDM clutch master cyliner

  8. Replacement clutch master cylinder for JDM GVR4

    I'll try that and see what happens, only other thing I can think of is to drill a hole in the piston to put a screw in to pull it out since it might have a plastic collar like the replacement.

  9. Replacement clutch master cylinder for JDM GVR4

    The only easy thing that came off after removing the ring was this shaft part.

  10. Replacement clutch master cylinder for JDM GVR4

  11. Replacement clutch master cylinder for JDM GVR4

    I'm unable to remove the piston, is there some other retaining ring I'm not seeing?

  12. Replacement clutch master cylinder for JDM GVR4

    I just double checked and the car is w/o cruise. I ordered a rebuild kit through RockAuto for a USDM '91. But I will also order a pair of these seals from JNZ. Thanks Guys

  13. Replacement clutch master cylinder for JDM GVR4

    Looks like I'll have to go the rebuild route for now. The lines are on opposite sides and the mounting points are different

  14. Replacement clutch master cylinder for JDM GVR4

    I recently acquired a JDM Galant VR-4 and while looking it over noticed the clutch master cylinder leaking past the seal into the cabin area. Where can I find a replacement one?E39A-0000868
See more
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top