Sold my Galant a while back and was going through a bunch of spare parts I have accumulated through other projects and ran across this. I figured one of you guys may have a use for it.For sale is a clutch pedal assembly/rebuild kit purchased from JNZ Tuning a couple of years ago. New, never...

Car has been sold.

Pending sale. I will post an update Saturday night.

Not really interested in an old bug, I'm really looking for a 99-00 7.3l, or a 91-93 Cummins I can use for a work truck.I'm sorry to hear you parted with your old car. From what I saw on here you had quite a car.

Well the time has come that I need to buy a work truck so I am contemplating selling my Galant. I've had the car for a the last two and a half years, and it just doesn't get driven much which is a shame. I have only put 5,700 miles on it since I've owned it. It is currently sitting at 188,723 on...

Looking for a good deal on a turbocharger for my Silverado. Have everything I need minus the turbo. Needs to have a t4 flange. Just thought I would see if someone had one they wanted gone.Loren

I have to agree with the above. I've had two transmissions built by Jack's shop. Both units performed flawlessly and I am not what you would call easy on them. It is a little more costly than just slapping in a used transmission but you will be much happier. Just my 2 cents.Loren

Thanks everyone for the input it is greatly appreciated. I am planning on getting a new tune and pushing it a little farther up the go fast scale (as if I wasn't pushing it hard enough already...). I believe having one of these in place before I do that is a good safety measure for my wallet...

I have some of this. Im located in Colorado springs.Lorenclick

I fixed a crankcase pressure problem a while back by simply replacing the pcv valve and have not had any problems since. Since then I have been thinking about doing what was done here. It sounds great, however, I would like to run check valves in place of the PCV valves, and a sealed catch can...

2000GTX pm me your address and i will get you a quote if you like. It is big, but it is lite.Loren

There is a shifter in the car. I don't know if it is the stock one but I will post a picture tomorrow after I get off.

Thanks for the knowledge, I'll update that in a few minutes. Also the mounting tabs are fine they just need new detail clips/pins that slide in.Trunk interior is spoken for you are next in line if it doesn't work out.

As the title states I am parting out 1720. The parts are located in Colorado Springs, the shell is now gone, for the most part what is below is what I have.All prices are for parts, you pay shipping costs and Paypal fees. My Paypal address is [email protected] intake manifold with...

I second the 044 in tank with 1600cc's. That is my setup and it works fine. Just ensure you run a fuel sock on the pump. You can get one from jay racing (for $35 I believe) that will work with e85.Loren