Its located around the same area. But since the donor half cut didn't have the sensor, I am not sure if it had a catalytic converter at all. Wondering if MMC connected it to ECM just to show a warning lightAnyways, I have ordered a wideband; expecting to get delivered by end of month. I...

Hello Rich! Great to hear from you. Been a while; hope you are well.We fixed the light, but not the sensor. Used a variable and set resistance to 0.15 ohms.Issue here is running lean. I am suspecting that this static 0.15 ohm resistance may be preventing ECM from setting appropriate AFR...

Hello Tektic, you are right this may never have been shipped to USA. Although I've seen EGR temperature sensor in wiring diagrams for California versions. Although I am not sure if this is the same sensor. ECU and harness match as they were plugged out from a half cut from Japan. Verified from a...

I have a 4G63 DOHC NA setup from 1988 JDM donor (SRGM2). The donor didn't come with exhaust high temperature sensor. Thanks to the forum members, I added a resistance (0.14 ohms) to address the instrument panel warning light. It is also relevant to mention that the setup has a single wire Oxygen...

I might as well use current forum rather than initiating a new thread.Problem with Rostra 250-1223 documentation:1. Diagram on page 21 for 'Normally Open Control Switch' is incorrect. In my opinion "ON" and "OFF" markings should replace each other. Image 1:Else it will contradict the...

Hi Rich,after months of waiting to have the original equipment in, I decided to go with Rostra 250-1223 universal (electric) cruise control module. Before ordering,I did the home work though, which helped and reducing the amount of effort. I was able to keep and use stock cruise control switch...

Hello Fellow,went to a scrapyard the other day and found the following rear diff & subframe. The seller doesn't know what car is it off from, and I don't know either. Images are posted below. Please see if anyone can identify what Mitsu has it come off from.Thank you,Ali

VIN shared in PM!Ali

Thank you Rich! Its good that I have the part numbers for electric setup that you always prefer. Although couldn't find a seller on the first go but will continue searching for one. Let me know if you come across a seller.Cheers mate!

Lol@ king of "it's not original"Waiting anxiously. Thanks for taking out time!Regards,Ali

Hi Rich & G,Thanks for all the info. You are right that the controller must match the actuator. I would prefer to utilize original wiring and get Mitsubishi parts. However this will be a last attempt to bring clarity before I resort to aftermarket alternatives.For actuators, there are 2...

Hello Everyone,I am trying to find parts and install Cruise Control in my Mitsubishi Galant 1988. The vehicle is RHD and pre-wired for Cruise Control. I have located the 20pin grip near the ETACS. And a non-utilized 4 pin grip on the firewal in engine bay (near brake booster). Also purchased...

Well, thank you again Rich!I have found this website that will confirm in 2 to 3 days whether a new part can be arranged. Looking Forward!Regards,Ali!

With your hands-on experience, you gotta be right. I verified that I got mislead by the documentation where it refers to two grips (D63 & D64) for interior temperature sensor in models with sunroof. Document image:

Hi Rich,As usual, great help. I can't find anyone selling new ones, so I guess will have to look in scrap market.I will also refer to the source and confirm whether there's two of these on the models with sunroof.Cheers!Ali