The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

Register Log in
  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Recent content by 1307nv

  1. FS: Parting out #1134

    Pm sent, thx.

  2. WTB: Front rack

    Still looking

  3. WTB: Front rack

    Hi, I'm looking for a 4WS front rack. I would like a non-leaking, but if not one that can be rebuilt would work.

  4. Fuel

    I got my dash pad and it was in great condition, smooth transaction, and great communication. Thx Fuel!!

  5. Build Thread of 1415/2000

    Shane let me know when you have it on the dyno, I want to check it out. Are you going to do it in Reno?

  6. WTB: 4 wheel sterring rack

    Shane yea I know where is coming from, it's leaking from the drivers side boot and both boot are torn. The hard lines look good, but it's starting to leave an oil spot every now and than. When are you doing yours?

  7. WTB: 4 wheel sterring rack

    I guess I should specify I need to front steering rack.

  8. WTB: 4 wheel sterring rack

    Aghhh...Thx but I can't make it to Nebraska.

  9. WTB: 4 wheel sterring rack

    Looking for a 4 wheel steering rack, prefer non leaking.

  10. Build Thread of 1415/2000

    Nice job Shane, I'm gonna have to check it out in person.

  11. Rear camber

    Thx, I already installed and had the car aligned. I also need new bolts for the front as well. The car must have been way off, now it drives soo much better.

  12. Factory MOD -- September 26th, 2015 -- Normal, IL

    For the west coast MOD they opened up the parking lot at 10pm (10th anniversary) the night before. Parking lot filled up fast and was set up model specific.

  13. Rear camber

    Thx all....order placed!

  14. Rear camber

    Thx Shane, I was gonna pick up a set of Ingalls at Summit today but I'll look into these as well and make a decision.

  15. Rear camber

    Thx for the feedback, the Ingalls looked pretty straight forward for install. I need an alignment and those look easier to install than the Whiteline. I think I might go that route.
See more
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top