The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

Register Log in
  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Recent content by dougmacho

  1. FS: stock intercooler pipes

    I purchased these, I only need the intake tube. What are you needing? PM me.

  2. Possibly broke shaft on fp 68hta

    I have about 5k miles on my turbo, was running fine then no boost. I believe the turbo shaft is broken, is it safe to assume i can send it to FP to have it rebuilt? Anyone else have issues with their FP 68hta?

  3. WTB: 1g twin piston calipers front

    Still need a good set.

  4. WTB: 1g twin piston calipers front

    I'm down, message me what you want for them. I need the carrier bracket too of course!

  5. WTB: 1g twin piston calipers front

    1g twin piston calipers, OEM.

  6. FS: Garage sale

    Is it possible to run with the cover off the air can/airbox?

  7. alternator drive belt

    Are you sure that's not the belt tensioner?Can you post a picture?

  8. Cyclone intake and motors have different firing order.

    Even if it's labeled, had to conclude that it wasn't anything else causing all the issues of a no start.....Etc....Just glad it's running again. Hallelujah

  9. Cyclone intake and motors have different firing order.

    Yes, thank you for clarifying.The coilpacks are mounted upside down on my car, either bc it's a cyclone motor or 90 and pre 90 coilpacks.

  10. Cyclone intake and motors have different firing order.

    Finally got my car back to normal, flipping firing order is different!!!!!!!I have it as 2,3 and 4,1.

  11. Could cyclone intake failure cause no start?

    Still unable to start my car, wondering if a failed actuator would cause a no start condition? I have a JDM cyclone motor, if it makes any difference.

  12. Car starts then dies, then won't start.

    Have some issues, hoping I can pick your brains a bit.Has a new coolant temp sensor also rewired it because it was brittle. Car starts fine when cold, then dies when I put it into gear. Revs start to die when shifter is in gear, does not dies when clutch is depressed. Doesn't startup after...

  13. What is the best way to fix this?

    3m has fabric adhesive spray you can purchase at home depot or Lowe's.

  14. misfires between 4-5kish only

    The car was running perfect with the tune, fast forward a year later and the coolant temp sensor went bad. The coolant temp sensor went bad and fouled the plugs. Bought new plugs and gapped them the same as the tuner had installed, at .2 I believe.Really wondering if it's somehow related to...

  15. misfires between 4-5kish only

    Need some help guys, misfires in 2nd and less in 3rd; it breaks up 4-5k then boosts fine. Replaced plugs and wires, then regapped plugs.....looks ok. Its the oddest thing, havent data logged since i don't have a pc.It is tuned by Whalen speed and has most all bolts ons, ecmlink, fp68 w/...
See more
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top