GalantVR4.org The Mitsubishi Galant VR-4 Forum
Galant VR-4 Forums » Galant VR-4 » Newbies » crank no start
Previous thread Next thread

crank no start


yubh8tn
Member
1384/2000


Galant VR-4 org Post #: 1250878 posted 06/04/21 02:13 PM     Remind Me!  Send Private Message   Edit Post      
Hey guys, got 1384 rebuilt completely and tuned, ran great, blew an intercooler hose, it sat for a couple weeks, and now it no longer starts.

After blowing the hose i taped it up in order to get home, so it still ran after that. It cranks but it just continuously turns over, barely any pops. Mechanical timing is correct, spark is strong, and I cant imagine compression dropping to 0 after sitting for two weeks. Plugs are wet so im getting fuel. Only thing thats unmeasurable is fuel pressure, but I can probably get an FPR soon.

I'm clueless here and would really appreciate some help. I have DSMLink v3 but i dont know how much help logs would be as i cant even start it



Belize Green 1384/2000
1998 Integra


Edited by yubh8tn (06/04/21 02:14 PM)

Posts: 116 | From: coeur d alene, idaho | Member Since: 08/21/19 | IP: (2600:100f:b05e:2) | Report this post to a Moderator

tyeler18
Junior Member
736/2000


Galant VR-4 org Post #: 1250893 posted 06/07/21 10:19 AM     Remind Me!  Send Private Message   Edit Post      
Without a fuel gauge on it you're pretty much guessing. Clean the plugs, disconnect the injector pigtails and spray some starter fluid in the intake tract. Does it start now? If so you're probably flooding it, check your coolant temp sensor reading in link if so. If it doesn't start then you need to reverify spark and then compression.



736/2000- FP Red, buschur turbo back, Evo 8 ecu, FIC2150, modified 1g Mishimoto X-line, evo 9 JIC coilovers, Powerstop Z26 brakes, and a trunk full of groceries.

Posts: 94 | From: Casa Grande, AZ | Member Since: 07/16/12 | IP: (174.26.244.142) | Report this post to a Moderator

yubh8tn
Member
1384/2000


Galant VR-4 org Post #: 1250901 posted 06/08/21 06:11 PM     Remind Me!  Send Private Message   Edit Post   
Compression is 0, mechanical timing is NOT correct. Crank gear is off by 6 or 7 teeth. I only checked cam gear alignment before. I must have not tightened the belt enough when I did timing and it slipped.

Damn



Belize Green 1384/2000
1998 Integra


Edited by yubh8tn (06/08/21 06:12 PM)

Posts: 116 | From: coeur d alene, idaho | Member Since: 08/21/19 | IP: (2600:100f:b02a:e) | Report this post to a Moderator


Pages: 1
Previous thread Next thread

Extra information
0 registered and 25 anonymous users are browsing this forum.

Galant VR4.org Moderator:  Hertz, curtis, steve, atc250r, jcgalntvr4-244, cheekychimp, jepherz, Rausch, toybreaker, iceman69510, pot, FlyingEagle 

Print Thread

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 171

Rate this thread


News & Events: News | Events
Galant VR-4: Newbies | General VR4 Discussions | Technical Discussions | How To and Info Archive
Marketplace: Parts For Sale | Cars For Sale | Good Guys | Bad Guys
Community: Members' Showcase

Contact Us | Privacy statement GalantVR-4.org

Generated in 0.065 seconds in which 0.055 seconds were spent on a total of 14 queries. Turbo powered.


Hertz's Galant VR-4 Page