†††GalantVR4.org The Mitsubishi Galant VR-4 Forum
Galant VR-4 Forums » Marketplace » Cars For Sale » FS: Black GVR-4 # 1680/2000 South Chicago Burbs
Previous thread Next thread

FS: Black GVR-4 # 1680/2000 South Chicago Burbs


boostme
Junior Member


Galant VR-4 org Post #: 1247641 posted 11/03/19 11:00 PM     Remind Me!  Send Private Message   Edit Post      
Update Nov 8 - Down pipe gasket has been replaced. I've detailed the car inside. Cleaned windows, door jams, trunk is clean, vacuumed the whole car. Added leather protector and interior protector as well. Shined up real good. Even the shift knob shines like a star.


Well I purchased my 1st GVR-4 to replace my 1G with no A/C and for hauling my 4 kids around. Lost my job earlier in the year and I finally had time to finish the mess.

Original Block popped a freeze plug, Long story short, I swapped a whole different motor.
Before the swap, I tore the engine down.
Holds a rock steady idle, ISC is still there.
New head gasket. ARP head studs torqued to 100 ft. lbs. with ARP lube
Intake Gasket and TBody gaskets.
All new gaskets everywhere. Oil pan and turbo does not leak at all.
I didn't have a downpipe gasket, so I'll admit theres a old one in there. Will replace when I have the gasket

Valve cover does not leak. New cam seals
NGK wires with NGk plugs gapped to .028
New Mopar belt. Save us both headaches and time
New balance shaft belt
You can slide a pin in and out the Tensioner so its perfect tension.
Original cluster has no working back lights. So a unit from Mr Pot was installed but has 192k
A/C is complete and intact. Needs a recharge though
Heater works perfectly good.
Both new E-brake cables with c-clips
Both rear inner axle boots were torn, so Napa brand were fitted
Replaced a rear caliper because the bleeder valve broke
ABS was removed and new front lines (already flared) were installed.
Was missing power steering hose, installed that
4WS was previously removed at some point
Inner tie rods were bent, boots cracked. Replaced that
Outer tie rods were shot. Replaced those. Not sure how I didn't notice during test drive
Trunk didnít open, was told it did. Replaced cable
Gas door doesnít pop open, even replaced the cable. Does open with your hand once popped
Slotted and drilled rotors. Brakes have good amount of life left

All lower support bars and gussets are intact.

*ON TO THE GOOD STUFF*
Had a blown, rigged up E3 16G, unfortunately not rebuildable said Mr Justin whitesell.So a good condition 14b was fitted
It is fed off the OFH and has a tee for a gauge. Gauge is installed but doesnít work. Just found that out. Possible bad sending unit
Ported o2 housing and slightly ported 2G manifold with OEM studs are 14mm not the 12 (edge studs)
2G MAF Ė has 1G to 2G adapter harness
Decent size FMIC with aluminum piping
Authentic TiAl blow off valve
Chipped ECU - see pics for details on what it has.
Pink top Evo 560cc? injectors. New seals, orings, head insulators
Walbro 255 HP fuel pump
Aeromotive Adjustable Fuel Pressure Regulator
Engine has 110k. All stock top to bottom
Trans has double 2nd synchro and was rebuilt according to previous owner
SBR 350 ( Yup been that long Iíve finished a project) which is basically a ACT 2600
Flywheel I believe is a Exedy. Car originally had a Stage 2 Exedy clutch. Its not heavy but not lightened
*All new fluids *
Power steering, clutch fluid, Valvoline 5W30 Synthetic, Valvoline gear oil for Transfer case and rear end. Valvoline trans gear fluid. Shit even Menards $2 washer fluid good to -20 įF!
Transmission axles seals
Transfer case does not leak.
Battery relocated to the rear with a sealed box. Has a breaker installed
Cruise control was removed, can include it if you ever need it.
93í Glass headlights with HID's
Headlight adjusters are busted so that's why they are clocked weird
Good, clean title

*BAD*
Rusted driver side fender
Rusty car underneath overall
Needs a proper alignment
Steering rack leaks

Iím trying to be honest as possible. I got screwed pretty bad by the previous young high school owner but hopefully someone can enjoy the car. Body is not perfect, donít feel bad about the salty roads we have to endure.

Original ad was $4300 so I'm asking the same price. Make me a good offer. I've put my heart and soul into this car, so please keep your negative comments to yourself.


click

Album above



Edited by boostme (11/20/19 10:51 AM)

Posts: 43 | From: Crete, IL | Member Since: 10/04/13 | IP: (2600:1:9285:6ee6) | Report this post to a Moderator

gvr4ever
Forever Member
347/1000


Galant VR-4 org Post #: 1247647 posted 11/04/19 08:37 AM     Remind Me!  Send Private Message   Edit Post      
Do you happen to know what shift knob that is? It's kinda neat looking.



1992 Nile black w/sunroof
15xK miles. 2nd owner since 1998

Posts: 5910 | From: central Indiana | Member Since: 08/06/02 | IP: (142.79.57.1) | Report this post to a Moderator

boostme
Junior Member


Galant VR-4 org Post #: 1247652 posted 11/04/19 02:38 PM     Remind Me!  Send Private Message   Edit Post      
No I don't know what brand it is.

click

Here's a link to a picture album. All those are from today. I washed and waxed the car. I'm sick and it's getting cold out so I didn't get a chance to get interior pictures.

Any questions, offers? Motivated seller

Posts: 43 | From: Crete, IL | Member Since: 10/04/13 | IP: (2601:244:5401:40) | Report this post to a Moderator

VR4_1752
Member
1752/2000


Galant VR-4 org Post #: 1247656 posted 11/04/19 06:52 PM     Remind Me!  Send Private Message   Edit Post      
Looks like a shift knob from a early 90ís Honda Accord.



91 Galant VR4
95 Civic with H22 swap STOLEN

Posts: 130 | From: LI, NY | Member Since: 08/01/06 | IP: (24.186.3.196) | Report this post to a Moderator

boostme
Junior Member


Galant VR-4 org Post #: 1247662 posted 11/05/19 12:31 PM     Remind Me!  Send Private Message   Edit Post      
I have a Eagle/Ross short block that I can sell cheap. Very good condition.

Posts: 43 | From: Crete, IL | Member Since: 10/04/13 | IP: (2601:244:5401:40) | Report this post to a Moderator

boostme
Junior Member


Galant VR-4 org Post #: 1247674 posted 11/07/19 03:36 PM     Remind Me!  Send Private Message   Edit Post      
I forgot to add the head has new Valve stem seals as well.

Original album has been updated with all the pics below but separate albums incase someone doesn't want to go thru then again.

Here's a album of when I obtained the car.
click


Blown turbo and no P/S hose, it made a very big mess all over the bay. I tried my best to clean it up with degreaser and rags. I don't have a drain in my garage so couldn't pressure wash the bay with the engine out.

Here's a album of the engine bay

click



Interior

click

Posts: 43 | From: Crete, IL | Member Since: 10/04/13 | IP: (2601:244:5401:40) | Report this post to a Moderator

boostme
Junior Member


Galant VR-4 org Post #: 1247687 posted 11/09/19 11:15 PM     Remind Me!  Send Private Message   Edit Post      
Rusty but it's got potential. Have cams? We can install them. Motor is clean as shit. Don't gotta touch it.


Edited by boostme (11/09/19 11:16 PM)

Posts: 43 | From: Crete, IL | Member Since: 10/04/13 | IP: (2601:241:8c80:30) | Report this post to a Moderator

boostme
Junior Member


Galant VR-4 org Post #: 1247693 posted 11/12/19 11:49 PM     Remind Me!  Send Private Message   Edit Post      
Good news, the transmission itself doesn't leak, it's the pass side axle seal. It is new, but must of messed it up installing is my guess.

So I'll be replacing that.

Posts: 43 | From: Crete, IL | Member Since: 10/04/13 | IP: (2601:244:5401:40) | Report this post to a Moderator

2002jm
Newbie


Galant VR-4 org Post #: 1247739 posted 11/19/19 08:36 PM     Remind Me!  Send Private Message   Edit Post      
Hi: Little confused about the turbo. Is it working fine, or blown right now?
thanks,
jm

Posts: 5 | From: boise idaho | Member Since: 02/24/17 | IP: (75.174.87.177) | Report this post to a Moderator

boostme
Junior Member


Galant VR-4 org Post #: 1247740 posted 11/20/19 10:49 AM     Remind Me!  Send Private Message   Edit Post      
The current turbo (14b) is perfect. Builds boost and no shaft play. I have also installed a exh manifold heat shield.

The old 16G, Justin tossed it out. CHRA was beyond repair. I should add pics of the previous owner's "rebuild" skills.

And I'm pretty sure I did install the lightweight Fidanza flywheel. I saw the one that was previously installed around my garage.


Edited by boostme (11/20/19 01:18 PM)

Posts: 43 | From: Crete, IL | Member Since: 10/04/13 | IP: (2601:244:5401:40) | Report this post to a Moderator

boostme
Junior Member


Galant VR-4 org Post #: 1247812 posted 11/30/19 03:11 PM     Remind Me!  Send Private Message   Edit Post   
$4000
Can meet partways if a deposit is left. $$

Posts: 43 | From: Crete, IL | Member Since: 10/04/13 | IP: (2601:244:5401:40) | Report this post to a Moderator


Pages: 1
Previous thread Next thread

Extra information
0 registered and 6 anonymous users are browsing this forum.

Galant VR4.org Moderator:  4orced4door, curtis, steve, atc250r, jcgalntvr4-244, cheekychimp, jepherz, Rausch, toybreaker, jnava, iceman69510, pot 

Print Thread

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 1389

Rate this thread


News & Events: News | Events
Galant VR-4: Newbies | General VR4 Discussions | Technical Discussions | How To and Info Archive
Marketplace: Parts For Sale | Cars For Sale | Good Guys | Bad Guys
Community: Members' Showcase

Contact Us | Privacy statement GalantVR-4.org

Generated in 0.079 seconds in which 0.043 seconds were spent on a total of 14 queries. Turbo powered.



Hertz's Galant VR-4 Page