The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

FS: 91 GVR4 Summit White 1929/2000 IL $4k SOLD

Status
Not open for further replies.

Myles

Well-known member
Joined
Aug 8, 2006
Messages
5,264
Location
Skokie, IL
Alright well being that I just picked up a bike, I'm thinking about parting with the galant.
The bad:
*The car has rust. Underneath and a little bit of surface rust on the drivers side A-pillar.
*In need of front brakes and possibly a drivers side front axle. I just replaced the axle not even 1500 miles ago but it's starting to make noise again.
*Drive Line vibrations.
*Car has no power steering. AWS line blew and I cut the PS belt to avoid damaging the pump.

Other than that the car runs great, has never left me stranded and is always ready for a fun night of boosting. There are some older pics in my members ride. I'll try and get some newer pics posted ASAP.

169,xxx miles on chassis.

Maintenance history:
At 129,000 miles.
Rebiuld of motor/turbo/tranny
ACT 2100 clutch

At 139,000 miles:
Rear calipers/rotors/pads
at 140,000 miles
Front struts
Front lower ball joints
Front axles
Front sway bar links
Pass side front wheel bearing
Front rotors
Front ceramic pads
Pennzoil syncromesh in tranny
Mobile 1 Synth gear oil in T-case
Alignment

At 143,000 miles:
New O2 sensor

At 149,500 miles:
New Valve cover seal
New speak plug gaskets
New half moon seal
New PCV
New Dura Last Spark Plug Wires

At 156,xxx miles:
Stainless steal brake lines
Replace T-case fluid w/ mobile 1 synth & Trans w/ Royle P

At 157,880 miles:
Timing Belt
Water Pump
Auto Tensioner
Balance shaft belt
All Seals
All pulleys except Harmonic Balancer

161,000
Rear Brembo rotors
Akebono Pads

168,xxx
New Bousch Knock Sensor
Rebuilt Throttle body
Drivers side axle

Go Fast Goodies:
B16G
FP Race Manifold
BoostinHard Head Dynamics Intercooler pipes w/ EVO MR IC
3" Intake
Forge BOV
Lower Shores MBC set at 15psi
3" turbo back exhaust w/ Flow Master Muffler
GM Trans Fluid Catch Can
Apexi Turbo Timer

Drivetrain:
Clutchnet 2xPP w/ 6 puck sprung

Fuel:
AEM Wide band Air/Fuel
Aeromotive AFPR
SAFC
3G MAS with Keydiver chip for 750 injectors
750cc FIC injectors
Walbro 255 pump w/ 8ga Rewire
Nology Spark Plug Wires

Suspension:
EVO MR Bilstien Struts W/ stock MR springs Thank you Enright Fabrication!
Knock off Whiteline strut bar

Aesthetics:
Thule 304 Roof Rack W/ Big mouth bike carrier.
EVO X Shift Knob
93 Headlights
JDM Single Bulb Corners w/ turn single/parking light reversed
Lancer OZ Rally Wheels (EVO 3 Overstock)
Chrome Grill
Bling Bling Battery Tray
Cruise Control Delete
Manual LS Antenna
TEL 1G steering wheel
TEL 1G shifter with leather boot
1990 LS trunk lid and tails

Sounds:
Pioneer AM/FM/CD deck With Aux cable.
 
Last edited by a moderator:

Polish

Well-known member
Joined
Jan 10, 2005
Messages
8,936
Location
NE, IN
I've been in this car a few times. It is nice and I'd buy it if I could.

Rides like a dream with the Evo suspension, one of the best I've ever been in and I am picky bitch.
The transmission shifted better than any DSM/GVR4 I've had, again I am picky. I wasn't driving but trust me, from just being in the passenger seat I could tell it was 100x smoother than my past cars.

Good luck with the sale. /ubbthreads/images/graemlins/cool.gif
 

CP

Well-known member
Joined
Aug 30, 2004
Messages
8,938
Location
West Simsbury, CT
Good luck with the sale Myles, but you're presenting the car to the "ain't got no money" crowd that we associate ourselves with /ubbthreads/images/graemlins/wink.gif
 

Myles

Well-known member
Joined
Aug 8, 2006
Messages
5,264
Location
Skokie, IL
^^^^^
Thanks Cy.

I usually try to post the car on CL to see what kind of market is there, because I know I'm gonna get shot down here. I've already got people asking me if I want to part it.
/ubbthreads/images/graemlins/rofl.gif
 

Myles

Well-known member
Joined
Aug 8, 2006
Messages
5,264
Location
Skokie, IL
Just gonna put this out there. I'd take $4K or best offer for the car as is.
 

Myles

Well-known member
Joined
Aug 8, 2006
Messages
5,264
Location
Skokie, IL
And a pic of the CF Speaker Gauge Pod, the usual bolster wear and up to date engine bay.




 

jcgalntvr4-244

Well-known member
Joined
Nov 9, 2003
Messages
3,135
Location
DesMoines Iowa
dropping the car for a bike .....Tool /ubbthreads/images/graemlins/devil.gif
 

Myles

Well-known member
Joined
Aug 8, 2006
Messages
5,264
Location
Skokie, IL
Alright there doesn't seem to be much interest like this.
 
Last edited:

frank1

Well-known member
Joined
Jul 17, 2008
Messages
68
Location
anaheim
CF Speaker Gauge Pod, where did you buy it at ?
 

Myles

Well-known member
Joined
Aug 8, 2006
Messages
5,264
Location
Skokie, IL
From a board member here. They're made by Paulo. I can't remember the name of his business. But from what I understand it's risky business trying to get one.
 

a2vr4

Well-known member
Joined
Aug 13, 2005
Messages
1,546
Location
Ann Arbor MI
/ubbthreads/images/graemlins/applause.gif now lets see that mightymax!!
~Brian
 
Status
Not open for further replies.
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top