The Mitsubishi Galant VR-4 Forum
Galant VR-4 Forums » Community » Members' Showcase » Blake Adams' 1992 Galant VR-4 50/1000
Previous thread Next thread

Blake Adams' 1992 Galant VR-4 50/1000

Bungie Battery

Galant VR-4 org Post #: 1230651 posted 07/29/16 05:23 PM     Remind Me!  Send Private Message   Edit Post   
Owner: Blake Adams
Location: KC, MO
Message Board Name: badams
Year: 1992
Number: 50/1000
Best 1/4 mile time: N/A
Dyno: N/A
Build thread: 50/1000

6 bolt stock block
Stock cams
Gates timing belt
Gates accessory belts
OEM Mitsubishi hydraulic tensioner
New water pump and timing components (Gates)
NGK BR7EIX plugs
Custom billet aluminum Galant VR-4 oil cap by Jason Everts

Walbro 255 fuel pump
Aeromotive A1000 AFPR (set @ 43.5 PSI BFP)
Deatschwerks fuel pump hardwire kit
-6 AN feed line to rail
New OEM fuel filter
FIC 1050cc injectors

Intake & Intercooler:
ETS bar and plate FMIC 24 x 10 x 3
2.5" intercooler piping
Custom 2.5" intake pipe
K&N 2.5" high flow air filter (RU-4950)

Turbo & Exhaust:
Big 16G turbo
Ported stock O2 housing
2G OEM exhaust manifold
CMP 2.5" turbo back exhaust

OEM radiator
Stant 13lb radiator cap
Stant 180* T-stat
Factory puller main fan
Factory pusher A/C fan

Personal steering wheel and shift knob combo
Paulo fiberglass dual gauge pod
VDO gauges (volt, boost)
Turboflanagan custom floor mats

EMS, Logging & Electronics:
ECMlink V3 full (tuned on speed density)
Innovate LC-2 wideband
Omni Power 4 bar MAP sensor
NGK plug wires
ECMlink boost control setup

Stock transmission (Red Line MT-90)
B2B 3 bolt non-LSD rear (Red Line Heavy ShockProof)
23 spline transfer case (Red Line Heavy ShockProof)
EHmotorsports short shifter
ACT 2100 pressure plate (MB010)
ACT Sprung 6-Puck Race Disc (6224704)
Competition Clutch lightweight steel flywheel
OEM release bearing
FTP stainless steel braided clutch line

Brakes, Wheels & Suspension:
BC BR series coilovers
Cusco front and rear strutbars
Tuner lug nuts
BBS wheels * 16x7 * 4x114.3 * Offset 44
Dunlop Direzza DZ102 tires 215/50 R16
2 pot GVR-4 front calipers
JMF aluminum brake fluid reservoir cap
Stoptech slotted front & rear rotors
Akebono brake pads
Techna-fit brake lines on all 4 corners

Edited by badams (12/17/19 04:30 PM)

Posts: 123 | From: KC, MO | Member Since: 06/16/14 | IP: (2602:306:c5f7:e2) | Report this post to a Moderator

Pages: 1
Previous thread Next thread

Extra information
0 registered and 1 anonymous users are browsing this forum.

Galant Moderator:  Hertz, curtis, steve, atc250r, jcgalntvr4-244, cheekychimp, jepherz, Rausch, toybreaker, jnava, iceman69510, pot, FlyingEagle 

Print Thread

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Thread views: 11861

Rate this thread

News & Events: News | Events
Galant VR-4: Newbies | General VR4 Discussions | Technical Discussions | How To and Info Archive
Marketplace: Parts For Sale | Cars For Sale | Good Guys | Bad Guys
Community: Members' Showcase

Contact Us | Privacy statement

Generated in 0.021 seconds in which 0.01 seconds were spent on a total of 14 queries. Turbo powered.

Hertz's Galant VR-4 Page