What tool is used to swage the end nuts on trans?

[pot]

This has probably been covered multiple times but I'm currently in the process of tightening down those two buggers and a punch isn't doing it. But I'd like to know from others, what tool are you guys using to swage the intermediate gear and input shaft?

Any help would be appreciated.

 

[prove_it]

Swage? Not sure what your doing sir. Are you saying your trying to knock the tabs in on the end nuts?

 

[iceman69510]

I have always used a hammer and blunt nose punch for the bending in of the nut.

 

[pot]

Thanks for the swift response Ryan/Dave -I'll quit being a sissy and hit the punch I have a little harder.

 

[prove_it]

It shouldn't be too hard to indent the tab area.