Need a little help

[tsitalon1]

Hey guys,

I'm embarrassed to say that I haven't replaced a head on a 4g63 in over 6 years and I have forgotten a few things. /ubbthreads/images/graemlins/smile.gif

The motor is still in the car and I need a way to clean the block surface without droping debris into the oil holes of the deck surface. I cannot remember the best method to do this. My best guess is a head bolt/washer droped into the oil hole to prevent debris from falling in while running a wire brush on the deck surface...

Any other suggestions?

 

[grocery_getter]

Paper towel in the holes and use razors to clean the deck surface. Hold blade at an angle and don't scratch the deck. Never use a wire brush on the deck surface. It needs to be smooth, not all scratched up!