yeti
Well-known member
ok so this thread is a bit diffrent then the n9ormal what to have done at the machine shop threads
i on the other hands dont know what to say to them should i just go down and give them my bare block or should i give them an assembled bottom end that needs rebuilding, also the same thing with the head..
my main question is will i pay alot more if they have to tear down the rest of the block, am i better off just tearing down the rest and bringing them every piece AND HAVE THEM INSPECT/CLEAN ALL THE PARTS( I CAN SEE THAT GETTING DAMN EXPENSIVE FOR a stock 6 bolt rebuild.) the pistons still look fine and same with the valves
ALS0 IM GOING TO READ THE MANUAL NOW ABOUT REBUILDING THE ENGINE.
should i teardown and inspect each part myself?
i on the other hands dont know what to say to them should i just go down and give them my bare block or should i give them an assembled bottom end that needs rebuilding, also the same thing with the head..
my main question is will i pay alot more if they have to tear down the rest of the block, am i better off just tearing down the rest and bringing them every piece AND HAVE THEM INSPECT/CLEAN ALL THE PARTS( I CAN SEE THAT GETTING DAMN EXPENSIVE FOR a stock 6 bolt rebuild.) the pistons still look fine and same with the valves
ALS0 IM GOING TO READ THE MANUAL NOW ABOUT REBUILDING THE ENGINE.
should i teardown and inspect each part myself?