The Mitsubishi Galant VR-4 Forum
Galant VR-4 Forums » Galant VR-4 » General VR4 Discussions » Hood Vent Dimensions?
Previous thread Next thread

Hood Vent Dimensions?


Galant VR-4 org Post #: 1251335 posted 10/12/21 08:19 AM     Remind Me!  Send Private Message   Edit Post   
Hey guys! I recently got a GVR4 model in a 3D model editor, I separated the hood vents from the model in hopes to 3D print it, cut a hole on my hood then screw the vents. Problem is, I absolutely have no idea about the dimensions of the vents. I did find dimensions for the vent placement on the hood but no luck on the vents itself.

So basically I'm requesting for the width and length dimensions of the vents from those who own a set of the genuine ones.

Here is the model that I have right now:

By the way, I don't need the height dimensions (I know the RS hood has a pit area for the vents to sit snuggly, fortunately the model didn't have that so I can simply place it without the RS hood pit and just cut a hole for the vents).

Edited by Cmp1516 (10/12/21 12:14 PM)

Posts: 8 | From: PH | Member Since: 08/05/21 | IP: ( | Report this post to a Moderator

Pages: 1
Previous thread Next thread

Extra information
0 registered and 13 anonymous users are browsing this forum.

Galant Moderator:  curtis, steve, atc250r, jcgalntvr4-244, cheekychimp, jepherz, Rausch, toybreaker, iceman69510, pot, FlyingEagle 

Print Thread

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Thread views: 93

Rate this thread

News & Events: News | Events
Galant VR-4: Newbies | General VR4 Discussions | Technical Discussions | How To and Info Archive
Marketplace: Parts For Sale | Cars For Sale | Good Guys | Bad Guys
Community: Members' Showcase

Contact Us | Privacy statement

Generated in 0.052 seconds in which 0.046 seconds were spent on a total of 14 queries. Turbo powered.

Hertz's Galant VR-4 Page