The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Removing Cluster Needles

Joined
Jul 2, 2018
Messages
20
Location
Perth
Anyone know how to remove the needles on the cluster?? Or even how to take apart the entire cluster? I think i may have a fault rpm gauge (still works but it sags and therefore is out or inaccurate).
I have another cluster with a good and working rpm gauge but the cluster is different ( has different warning lights and speedo only goes to 180) (Mines must be a auspec one as it goes to 240???)
Thanks!
 

RayH

Well-known member
Joined
Apr 9, 2001
Messages
2,703
Location
NJ
Been a long time since I've done it, there's a couple screws that you remove from the black trim surrounding the instrument panel and after that you can remove the screws which hold the cluster. A couple wiring harnesses that need to be disconnected in the back and then the whole thing comes out. Needles are friction fit and pull straight off. I believe you can use a fork for leverage, just make sure you mark their position so you can get them back on correctly.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top