The Mitsubishi Galant VR-4 Forum
Galant VR-4 Forums » Galant VR-4 » General VR4 Discussions » Made fuel filler hose
Previous thread Next thread

Made fuel filler hose

Junior Member

Galant VR-4 org Post #: 1245173 posted 01/22/19 10:23 PM     Remind Me!  Send Private Message   Edit Post   
My old filler hose wore a hole through itself, and I've had to make due with a radiator hose pressed into service. I knew this wasnt going to serve as a long term solution. I ordered a 1 5/8" ID 90 degree elbow, a 45 degree elbow, a stainless coupler, and 4 hose clamps. After trimming the legs, I'd say it fits pretty darn good. If there is enough interest, I'd be happy to make a few for other members. Last I heard, these aren't available otherwise.

Posts: 81 | From: Ventura, CA | Member Since: 03/01/15 | IP: ( | Report this post to a Moderator

Pages: 1
Previous thread Next thread

Extra information
0 registered and 28 anonymous users are browsing this forum.

Galant Moderator:  curtis, steve, atc250r, jcgalntvr4-244, cheekychimp, jepherz, Rausch, toybreaker, iceman69510, pot, FlyingEagle 

Print Thread

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Thread views: 338

Rate this thread

News & Events: News | Events
Galant VR-4: Newbies | General VR4 Discussions | Technical Discussions | How To and Info Archive
Marketplace: Parts For Sale | Cars For Sale | Good Guys | Bad Guys
Community: Members' Showcase

Contact Us | Privacy statement

Generated in 0.119 seconds in which 0.111 seconds were spent on a total of 14 queries. Turbo powered.

Hertz's Galant VR-4 Page