The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

question on rear hubs

4nmscle

Well-known member
Joined
May 31, 2007
Messages
362
Location
Harvest,AL
do the rear hubs on a vr4 press in or are they held in with the nut to the axle cup?
 

Terry Posten

Well-known member
Joined
Dec 16, 2003
Messages
9,009
Location
Davenport, Iowa USA
Nut, but it wont just fall out. Once you take the nut off, remove the cup. Thread the nut back on a few threads and then use a dead-blow hammer. A few taps and it should slide out. Once you have it moving, remove nut and tap the rest of the way out.
 

4nmscle

Well-known member
Joined
May 31, 2007
Messages
362
Location
Harvest,AL
that is what i was hoping to hear. thanks bro!
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top