The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

o2 bung from ecu harness...

well since my car is not acually a vr4, but a gsx clone with everything vr4.. i need to get my a/f gauge working so i can somewhat tune my car. i was looking for the female o2 sensor coneection but no luck. is this the one since i have a gsx?


IMG01132.jpg


IMG01127.jpg


IMG01126.jpg


and since its socketed eeprom( keydiver) will the ecu plugs still be the same and can i run a splice for the gauge into the o2 wire on the ecu?

i dont want to short anything out.
 

Nate

Well-known member
Joined
Feb 23, 2001
Messages
944
Location
Worcester, Pa
That appears to be the one to use. I've used that, and also spliced into the ECU wire, but I prefer to use that wire for an O2 gauge.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top